28 lines
1.6 KiB
Markdown
28 lines
1.6 KiB
Markdown
GON NerD
|
|
========
|
|
|
|
A Korean Custom TKL.
|
|
|
|
Keyboard Maintainer: QMK Community
|
|
Hardware Supported: GON NerD TKL PCB
|
|
Hardware Availability: [gonskeyboardworks.com](http://www.gonskeyboardworks.com/pcbs-and-controllers/60-nerd-tkl-ver20-pcb.html)
|
|
|
|
Make example for this keyboard (after setting up your build environment):
|
|
|
|
make gonnerd:default
|
|
|
|
See [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) then the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information.
|
|
|
|
## Changing Bootloader
|
|
|
|
It's not possible to simply flash this firmware on the GON NerD keyboard as the original bootloader does not support DFU connections.
|
|
|
|
It is possible to change the bootloader of the GON NerD with an ISP programmer. A guide on how to change the bootloader on your GON NerD can be found here:
|
|
[Converting NerD60 to TMK](https://deskthority.net/wiki/Converting_NerD60_to_TMK). After changing the bootloader you can flash your QMK keymap onto the keyboard.
|
|
|
|
_After changing the bootloader on your GON NerD PCB you will not be able to go back to the original firmware and the official configuration software will
|
|
not work anymore. You will lose your warranty and official support from GON!_
|
|
|
|
## Reset button
|
|
|
|
To run the `make dfu` command to flash keymaps onto the board, you need to put the board into DFU mode. As the GON NerD PCBs do not have a reset button on the board to put it into DFU mode, be sure to include a `RESET` button on your keymap. Otherwise you'll have to unscrew your keyboard from the case and short the GND and RST pins.
|